Revival Defense & Forward Controls Design
1210RF Muzzle Brake & Plan B Suppressor Mount
The 1210RF (Revival Defense, Forward Controls) is a Single Port Muzzle Brake and Plan B / Rearden Atlas Compatible Silencer Mount Threaded in 5/8x24 designed in collaboration between Forward Controls Design and Revival Defense
ABOUT THE RF SERIES MUZZLE DEVICES
The RF Series Muzzle Devices were designed to be compact yet effective standalone muzzle devices which also serve as a rugged and reliable suppressor mount that doesn’t add unnecessary weight or length to the front of your rifle. We set out to design a practical device for end users who want a no frills, high performance standalone device that they can securely attach their suppressor to.
Features
Single Chamber Muzzle Brake
Muzzle Brakes can greatly reduce felt recoil, aiding in quicker follow up shots and better target tracking, but this does not come without a cost. Muzzle brakes greatly increase the report of the gun shot along with the flash signature, which is why as a standalone device we typically lean towards a flash hider. However, muzzle brakes act as a sacrificial first baffle, so for those using a suppressor they may be more appealing, especially on a setup that is going to almost always have a suppressor on it.
Plan B & Rearden Atlas Compatible Suppressor Mount
Our RF Series of Muzzle Devices feature a suppressor mount compatible with Rearden Atlas and Plan B Type Mounts. This suppressor mounting system utilizes a taper and threads to ensure a proper seal that is repeatable and reliable without adding unnecessary weight or length to the system.
Nitride Finish
The Nitriding process greatly increases the surface hardness of the muzzle device while lending itself to a tighter seal in the suppressor itself.
Standardized Wrench Flats
RF Series Muzzle Devices Feature 3/4” Wrench Flats for ease of installation. The FCD JMW, Armorers Wrench or any other 3/4" Wrench can be used for installation
What’s Included
1x 1210RF Muzzle Device
1x Rocksett Packet
Specifications
Installation
The 1210RF must be timed. The Cygnus and RD logo should be at the bottom with the unengraved side facing top dead center when properly installed. Allow Rocksett to cure for at least 12 hours before use. Make sure to check alignment with your suppressor before use.
*Only use the wrench flats for installation of your muzzle device. Do not use a screwdriver or any other tool to apply torque through the ports. The FCD JMW is specifically designed for installation of suppressor mounts and available HERE
*Use on Q Cans will void your warranty
